• Cisco 1800 series (modular)
• Cisco 2800 series
• Cisco 3800 series
• Cisco ICS 7750

The Cisco WIC-2T 2-Port Serial WAN Interface Card features Cisco`s new, compact, high-density Smart Serial connector to support a wide variety of electrical interfaces when used with the appropriate transition cable. Two cables are required to support the two ports on the WIC. Each port on a WIC is a different physical interface and can support different protocols such as Point-to-Point protocol (PPP) or Frame Relay and Data Terminal Equipment/Data Communications Equipment (DTE/DCE).

Cisco WIC-2T Features:

The WIC-2T provides two serial ports using the Smart Serial connector.

• Asynchronous support with a maximum speed (per port) of 115.2 Kbps, minimum 600 bps. If you need to run at speeds lower than 600 bps, use the AUX port instead.

• Synchronous support with a maximum speed of 8 Mbps per port.

  • Supports one port at 8 Mbps when used in NM-1FE1R2W, NM-1FE2W, NM-2FE2W, or NM-2W, or Cisco 2600 chassis WIC slots. All other WIC ports on that network module or Cisco 2600 chassis must not be used.

  • Supports two ports at 4 Mbps each when used in NM-1FE1R2W, NM-1FE2W, NM-2FE2W, or NM-2W, or Cisco 2600 chassis WIC slots. All other WIC ports on that network module or Cisco 2600 chassis must not be used.

  • Supports 8 Mbps on all ports simultaneously on 2691, 3725, and 3745. No restrictions. Maximum six ports at 8 Mbps each.

The 2811 system was tested delivering full telephony services to the local office, including CCME (Cisco CallManager Express, an IOS-software-based IP-PBX), voicemail, auto-attendant, conferencing, PRI T1 trunk to the PSTN, and analog-phone and fax services.

The 2811 ran a late-beta version of IOS 12.3(11)T in the test bed. Miercom verified that, while running this impressive array of additional services (see table on page 3), the 2811 could sustain bi-directional traffic over a two-T1-capacity MLPPP, IP-WAN link (see below). This router is designed to deliver security and data services at two-T1 or two-E1 rates.

Cisco 2811 Functionalities:

​

• Firewall, Voice over IP Gateway (VoIP)
• 1.6 Gbps Backplane Capacity
• 2-port Built-In Switch Built-In Interface
• 10/100 Base-T LAN Interfaces Interface
• Ethernet RJ-45 Console Port Interface
• 1 x USB Additional Interface
• IEEE 802.3 CSMA/CD or Ethernet, IEEE 802.3u 100 Mbps (Fast Ethernet) LAN Standards
• ATM, Frame Relay, IP, ISDN, QSIG, RTP Protocols
• HTTP, SNMP 3 Remote Management Protocol
• IPSec VPN Protocols
• 3DES, DES Encryption Standards
• ADSL Lite (G.Lite ITU G.992.2), HDSL (ITU G.991.1), SHDSL (G.SHDSL ITU G.991.2) DSL Standards
• Activity, Alert, Link, Power, Status LED Indicators advanced services to multiple T1/E1/xDSL WAN rates
• Increased density through High-Speed WAN Interface Card Slots
• Enhanced Network Module Slot
• AIMs, NMs, WICs, VWICs, and VICs
• 2 Integrated 10/100 Fast Ethernet ports
• On-board encryption
• 1500 VPN tunnels with the AIM-EPII-PLUS Module
• Analog and digital voice call support

The Cisco 2811 Integrated Services Router provides the following support:

​

• Wire-speed performance for concurrent services such as security and voice , and advanced services to multiple T1/E1/xDSL WAN rates
• Enhanced investment protection through increased performance and modularity
• Increased density through High-Speed WAN Interface Card Slots (four)
• Enhanced Network Module Slot
• Support for over 90 existing and new modules
• Support for majority of existing AIMs, NMs, WICs, VWICs, and VICs
• Two Integrated 10/100 Fast Ethernet ports
• Optional Layer 2 switching support with Power over Ethernet (PoE) (as an option)
• Security

   

   

  • On-board encryption
  • Support of up to 1500 VPN tunnels with the AIM-EPII-PLUS Module
  • Antivirus defense support through Network Admission Control (NAC)
  • Intrusion Prevention as well as stateful Cisco IOS Firewall support and many more essential security features
• Voice

   

   

  • Analog and digital voice call support
  • Optional voice mail support
  • Optional support for Cisco CallManager Express (Cisco CME) for local call processing in stand alone business for up to36 IP Phones
  • Optional support for Survivable Remote Site Telephony support for local call processing in small enterprise branch offices for up to 36 IP phones